Make your own free website on Tripod.com

350/400F O ring mounting instructions


Smallest O-ring (4x): For secunday mainjet (the small tube that is under the main jet). (#27). This ring prevents the engine from leaking fuel along side the jet, so the bike is not running too rich.

Second O-ring (4x): Float seat (#2). This ring prevents the engine from leaking fuel along side the seat, so the bike will not leak (at least not with this cause).

Third O-ring (4x): Seal for inlet manifold (9). When this ring is worn you may have an airleak at this spot, which causes the engine to un lean and therefor bad.

Largest O-ring (4x): Float chamber body (for mounting use a tiny bit of fluid gasket). This ring takes care of sealing the float chamber to the carb body.

 

Nederlands  
Kleinste O-ring (4x): Voor secundaire hoofdsproeier (Het kleine busje wat onder de hoofdsproeier zit. (27)

Tweede O-ring (4x): Voor Vlotter zitting (2)

Derde O-ring (4x): Afdichting inlaat flenzen tussen kop en carburateur rubbers (9)

Grootste O-ring (4x): Vlotterkamer (vastzetten met een minimale hoeveelheid siliconenpakking t.b.v. montage)

René van Maanen, +31(0)6 1484 6559 cmvanmaanen@hetnet.nl